400 Corbon Full Length Die Set Rcbs
400 Corbon Full Length Die Set Rcbs.
This 400 Crobon Two-Die Full Length Die Set is intended for reloading bottleneck cases, and consists of a Full-Length Sizer Die with an Expander-Decapping Unit, and a Seater Die with Bullet Seater Plug. The Full-Length Sizer Die brings the case to SAAMI minimum cartridge dimensions. It sizes the outside of the case, de-primes and expands the neck to accept the bullet. The die has vents to prevent case damage caused by trapped air and for excessive lubricant. Headspace is held to minimum tolerances to avoid changing the case body length during full length sizing. The included Seater Die has a built-in roll crimper to secure the bullet at the same time as it’s seated.
400 Corbon Trim Die Rcbs.
This 400 CorBon hardened trim die is designed to be used with a file to run a case into a die and cut it to length.
9mm Far 3-Die Set Rcbs.
The 9mm FAR 3-Die Roll Crimp Set is for loading straight-wall cartridges. Its steel Sizer Die sizes the case and de-primes. Note: Cases must be lubricated. The Expander Die expands the case to the proper diameter to accept the bullet, and it imparts case mouth flare/bell for bullet feeding. The Seater Die seats the bullet and roll crimps.